User's Manual
Table Of Contents
- User Manual
- 1 Introduction
- 2 Components & Controls
- 3 Preparations
- 4 Initial Use
- 5 Start Diagnostics
- 6 Maintenance Reset
- 6.1 Oil Reset Service
- 6.2 Electronic Parking Brake Reset
- 6.3 Steering Angle Calibration
- 6.4 ABS Bleeding
- 6.5 Tire Pressure Monitor System Reset
- 6.6 Gear Learning
- 6.7 IMMO Service
- 6.8 Injector Coding
- 6.9 Battery Maintenance System Reset
- 6.10 Diesel Particulate Filter (DPF) Regeneration
- 6.11 Electronic Throttle Position Reset
- 6.12 Gearbox Matching
- 6.13 AFS (Adaptive Front-lighting System) Reset
- 6.14 Sunroof Initialization
- 6.15 Suspension Calibration
- 6.16 EGR Adaption
- 6.17 Seats Calibration
- 6.18 Tyre Reset
- 6.19 Coolant Bleed
- 6.20 AdBlue Reset (Diesel Engine Exhaust Gas Filter)
- 6.21 NOx Sensor Reset
- 7 Software Update
- 8 SmartLink Diag.
- 9 TPMS
- 10 ADAS
- 11 User Info
- 12 Others
- 13 J2534 Reprogramming Using SmartLink C
- 14 FAQ
- 15 Glossary of Terms & Abbreviations
- 页面提取自－User Manual
Safety & Accessory
Initial UseDiagnosticsFAQ & Care
Product Prole
27
www.x431.com +86 755 8455 7891
LAUNCH
PAD VII
User Manual
Warning: Retrieving and using DTCs for troubleshooting vehicle operation is only one part of an overall
diagnosc strategy. Never replace a part based only on the DTC denion. Each DTC has a set of tesng procedures,
instrucons and ow charts that must be followed to conrm the locaon of the problem. This informaon can be
found in the vehicle’s service manual.
Freeze Frame: When an emission-related fault occurs, certain vehicle conditions are recorded by the on-
board computer. This information is referred to as freeze frame data. Freeze frame data includes a snapshot
of critical parameter values at the time the DTC is set.
Help: Tap to view the help information.
Code Search: Tap it to search for more information about the current DTC online.
Report: To save the current data in text format. All diagnostic reports can be accessed from User Info -> My
Reports -> Diagnostic Report.
C. Clear Fault Code
After reading the retrieved codes from the vehicle and certain repairs have been carried out, you can
engine light will illuminate as soon as the problem that cause the DTC to set manifests itself.
Tap Clear Fault Code on the test function selection screen, a confirmation dialog box pops up on the
screen. Tap Yes and the system will automatically delete the currently existing trouble code.
Note: Aer clearing, you should retrieve trouble codes once more or turn ignion on and retrieve codes again.
If there are sll some trouble codes in the system, please troubleshoot the code using a factory diagnosis guide,
then clear the code and recheck.
D. Read Data Stream
also be used to guide vehicle repair.
Danger: If you must drive the vehicle in order to perform a troubleshoong procedure, always have a second
person help you. Trying to drive and operate the diagnosc tool at the same me is dangerous, and could cause a
serious trac accident.
Tap Read Data Stream on the test function selection screen, the system will display data stream items.