User's Manual

Safety & Accessory
Initial UseDiagnosticsFAQ & Care
Product Prole
25
www.x431.com [phone]
LAUNCH
PAD VII User Manual
report.
Note: Diagnosc report is classied into three categories: Pre-Repair report, Post-Repair report and Diagnosc
Scan. No maer which type you saved the report as, the report type will be appended as a tag on the upper right
corner of the diagnosc report for easier idencaon.
To facilitate the comparison of the pre-repair and post-repair reports and get accurate test result, please make
sure you saved the right type of the diagnosc report.
To save the report as a common diagnosc report, select Diagnosc Scan.
On the report details page, tap Save to save it. All diagnostic reports can be accessed from User Info ->
My Reports -> Health Report.
Help: Tap to view the help information of the selected DTC item.
Compare Results

The DTC status
of post-repair
The DTC status
of pre-repair
Note: Before performing this funcon, please make sure that:
• You have saved a pre-repair report of the currently tested vehicle, and
• You have already made some repairs and service and cleared the DTCs aer the pre-repair reported is generated.
Otherwise, no dierences exist between the pre- and post- repair reports.
Clear DTC: Tap to clear the existing diagnostic trouble codes.
Note: Clearing DTCs does not x the problem(s) that caused the code(s) to be set. If proper repairs to correct
the problem that caused the code(s) to be set are not made, the code(s) will appear again and the check engine
light will illuminate as soon as the problem that cause the DTC to set manifests itself.