User's Manual
Table Of Contents
- User Manual
- 1 Introduction
- 2 Components & Controls
- 3 Preparations
- 4 Initial Use
- 5 Start Diagnostics
- 6 Maintenance Reset
- 6.1 Oil Reset Service
- 6.2 Electronic Parking Brake Reset
- 6.3 Steering Angle Calibration
- 6.4 ABS Bleeding
- 6.5 Tire Pressure Monitor System Reset
- 6.6 Gear Learning
- 6.7 IMMO Service
- 6.8 Injector Coding
- 6.9 Battery Maintenance System Reset
- 6.10 Diesel Particulate Filter (DPF) Regeneration
- 6.11 Electronic Throttle Position Reset
- 6.12 Gearbox Matching
- 6.13 AFS (Adaptive Front-lighting System) Reset
- 6.14 Sunroof Initialization
- 6.15 Suspension Calibration
- 6.16 EGR Adaption
- 6.17 Seats Calibration
- 6.18 Tyre Reset
- 6.19 Coolant Bleed
- 6.20 AdBlue Reset (Diesel Engine Exhaust Gas Filter)
- 6.21 NOx Sensor Reset
- 7 Software Update
- 8 SmartLink Diag.
- 9 TPMS
- 10 ADAS
- 11 User Info
- 12 Others
- 13 J2534 Reprogramming Using SmartLink C
- 14 FAQ
- 15 Glossary of Terms & Abbreviations
- 页面提取自－User Manual
Safety & Accessory
Initial UseDiagnosticsFAQ & Care
Product Prole
15
www.x431.com +86 755 8455 7891
LAUNCH
PAD VII
User Manual
4.3.3 Vehicle Connection
through a standardized DLC.
connection, and in some cases supplies 12V power through the cigarette lighter receptacle or a
connection to the vehicle battery.
SmartLink C device To Vehicle's DLC port
, proceed as follows:
SmartLink C device
To Vehicle's DLC port
Non-16pin connector
Notes:
If the power supply on vehicle diagnosc socket is insucient or the power pin is damaged, you can get power via
either of the following ways:
A. Via Baery clamps cable (oponal): Connect one end of the baery clamps cable to the power jack of the OBD I
adaptor box, and the other end to the vehicle’s baery.
SmartLink C device OBD II extension cable
To Vehicle's DLC port
To Cigarette lighter
receptacle
OBD I adaptor
Non-16pin connector
Cigarette lighter cable
B. Via Cigaree lighter cable (oponal): Connect one end of the cigaree lighter cable to the power jack of the OBD
I adaptor box, and the other end to the cigaree lighter receptacle.
SmartLink C device OBD II extension cable
To Vehicle's DLC port
To vehicle's battery
OBD I adaptor
Non-16pin connector
Battery clamps cable
4.4 Communication Setup
There are 3 kinds of ways available for the tablet to communicate with the SmartLink C device: Wi-Fi,
After the sign-up is successfully completed, the Wi-Fi communication between the tablet and the SmartLink