User's Manual
Table Of Contents
- User Manual
- 1 Introduction
- 2 Components & Controls
- 3 Preparations
- 4 Initial Use
- 5 Start Diagnostics
- 6 Maintenance Reset
- 6.1 Oil Reset Service
- 6.2 Electronic Parking Brake Reset
- 6.3 Steering Angle Calibration
- 6.4 ABS Bleeding
- 6.5 Tire Pressure Monitor System Reset
- 6.6 Gear Learning
- 6.7 IMMO Service
- 6.8 Injector Coding
- 6.9 Battery Maintenance System Reset
- 6.10 Diesel Particulate Filter (DPF) Regeneration
- 6.11 Electronic Throttle Position Reset
- 6.12 Gearbox Matching
- 6.13 AFS (Adaptive Front-lighting System) Reset
- 6.14 Sunroof Initialization
- 6.15 Suspension Calibration
- 6.16 EGR Adaption
- 6.17 Seats Calibration
- 6.18 Tyre Reset
- 6.19 Coolant Bleed
- 6.20 AdBlue Reset (Diesel Engine Exhaust Gas Filter)
- 6.21 NOx Sensor Reset
- 7 Software Update
- 8 SmartLink Diag.
- 9 TPMS
- 10 ADAS
- 11 User Info
- 12 Others
- 13 J2534 Reprogramming Using SmartLink C
- 14 FAQ
- 15 Glossary of Terms & Abbreviations
- 页面提取自-User Manual
Safety & Accessory
Initial Use
Diagnostics
FAQ & Care
Product Prole
10
www.x431.com +86 755 8455 7891
LAUNCH
PAD VII
User Manual
Disconnect from a WLAN Network
1. On the Home screen, tap Settings -> Network & in-
ternet -> Wi-Fi.
2. Tap the network with a Connected status,
then tap Forget.
3.5 Adjust Brightness
Note: Reducing the brightness of the screen is helpful to conserve the baery power.
1. On the home screen, tap Settings -> Display ->
Brightness level.
2. Drag the slider to adjust it.
3.6 Change System Language
The tool supports multiple system languages. To change the language of the tool, please do the following:
1. On the home screen, tap Settings -> System ->
Language & input -> Languages.
2. Tap Add a language, and then choose the desired
language from the list.
3. Tap and hold the desired language and drag it
to the top of the screen and then release it, the
system will change into the target language.
3.7 Set Standby Time
system enters sleep mode to save power.
1. On the home screen, tap Settings -> Display -> Ad-
vanced -> Sleep.
2. Choose the desired sleep time.










