User Manual

LAUNCH X-431 PAD V User Manual

vehicle’s configuration as follows:

A. OBD II Vehicle Connection: Plug one end of the diagnostic cable into the

vehicle’s DLC, and the other end into the diagnostic socket of the VCI, and

then tighten the captive screws.

B. Non-OBD II Vehicle Connection: For vehicles with non-OBD II diagnostic

socket, a non-16pin connector (adaptor cable) is required.

*Notes:

a). For commercial vehicles, refer to the above connection method to proceed.

b). For passenger vehicles, replace the “Non-16pin connector” with “OBD I adaptor” +

“non-16pin connector (for passenger vehicles)”. Other connections shall also apply.

4.5 Communication Setup

There are two kinds of ways available for the tablet to communicate with the VCI

device: Wi-Fi and USB cable.

The USB cable connection is a simple & quick way to establish communication

between the tablet and the VCI. After properly connecting the USB cable from