User Manual

38
LAUNCH Creader VII+ & Creader VIII User's Manual
Figure 7
11. Once all steps are complete, reinsert the TF card into the tool and power
the tool via USB cable or via OBD II cable (one end to OBD II connector
of Creader VII+ / Creader VIII and the other end on the vehicle’s DLC). A
dialog box (Note: If only diagnostic softwares are updated and no rmware
packages are downloaded in Figure 7, this box will not appear) prompting you
to upgrade will pop up on the screen (See Figure 8), select OK to proceed.
Figure 8 Figure 9
12.The registration process is now complete, your Creader VII+ / Creader VIII is
now ready for use (See Figure 9).