User Manual

8
LAUNCH Creader VII+ & Creader VIII User's Manual
4. Connection
4.1 Install TF card
1) Take out the TF card from package box.
2) Insert the TF card into the Creader VII+ / Creader VIII TF card slot
perpendicularly. Make sure is fully inserted in the right place with the “micro”
label facing upward.
Note: You can hear a clicking sound if you insert the TF card in the right place.
Press the card slightly, it will be ejected automatically.
4.2 Connect Creader VII+ / Creader VIII
Turn the ignition off.1.
Locate vehicle’s DLC socket: it provides standard 16 pins and is generally 2.
located on driver’s side, about 12 inch away from the center of dashboard.
See Figure 2-2. If DLC is not equipped under dashboard, an label indicating
its position will be given. In case no DLC is found, please refer to Automobile
Repair Manual.
Plug one end the diagnostic cable into the OBD II 16 pin connector of Creader 3.
VII+ / Creader VIII, and connect the other end to the vehicle’s DLC.
Plug one end of the diagnostic
cable to diagnostic interface,
then connect the other end to
vehicle's DLC.
Figure 4-1
Turn the ignition on. Engine can be off or running.4.
After nishing, the system will start initializing. After initialization, the system 5.
will enter the main menu interface. See 4-2.