User's Manual
Table Of Contents
- 1 Overview
- 1.1 Vehicle Coverage
- 2 Product Descriptions
- 3 Initial Use
- 4 Diagnose
- 5 Reset
- 5.1 Oil Reset Service
- 5.2 Electronic Parking Brake Reset
- 5.3 Steering Angle Calibration
- 5.4 ABS Bleeding
- 5.5 Gear Learning
- 5.6 IMMO Service
- 5.7 Injector Coding
- 5.8 Battery Maintenance System Reset
- 5.9 Diesel Particulate Filter (DPF) Regeneration
- 5.10 Electronic Throttle Position Reset
- 5.11 Gearbox Matching
- 5.12 AFS (Adaptive Front-lighting System) Reset
- 5.13 Sunroof Initialization
- 5.14 Suspension Calibration
- 5.15 EGR Adaption
- 5.16 Seats Calibration
- 5.17 Tyre Reset
- 5.18 Coolant Bleed
- 5.19 AdBlue Reset (Diesel Engine Exhaust Gas Filter)
- 5.20 NOx Sensor Reset
- 5.21 AC System Initialization
- 5.22 High Voltage Battery Detection
- 5.23 Windows Calibration
- 5.24 Language Change
- 5.25 A/F Reset
- 5.26 Transport Mode
- 5.27 Stop/Start Reset
- 5.28 Intelligent Cruise Control System Reset
- 5.29 Engine Power Balance Monitoring
- 5.30 Gas Particulate Filter (GPF) Regeneration
- 5.31 Motor Angle Calibration
- 6 Data
- 7 Upgrade
- 8 Add-on Modules
- Warranty
44
LAUNCH Professional 919X User Manual
5.22 High Voltage Battery Detection
This function is used for high voltage battery diagnosis and status information
detection.
5.23 Windows Calibration
This function is used to perform door window matching to recover the ECU
initial memory, and recover the automatic ascending and descending function
of power window.
5.24 Language Change
This function is used to change system language of vehicle center console.
5.25 A/F Reset
This function is applied to set or learn air/fuel rate parameters.
5.26 Transport Mode
To lower vehicle power consumption, user may perform the following
operations: limit vehicle speed, not wake up the network for door open and
disable remote key etc. In this case, deactivating transport mode is needed to
recover vehicle being normal.
5.27 Stop/Start Reset
This function is used to open or close the automatic Start/Stop function via
setting the hidden function in ECU (The precondition is vehicle equipped with
hidden function and hardware support).
5.28 Intelligent Cruise Control System Reset
This function is used to matching the intelligent cruise control module after it is
replaced or repaired.
5.29 Engine Power Balance Monitoring
This function is used to monitor crankshaft acceleration in the power stroke of
each cylinder, to determine the relative power provided by each cylinder.
5.30 Gas Particulate Filter (GPF) Regeneration
This function is used to perform the GPF replacement or regeneration after the