Installation Manual

Take CR8011 for example:

Follow the steps described as below to perform the registration and

update:

1. Go to the launch website: mycar.x431.com and click Products >

CR8011.

2. Download and install the Update Tools and launch the program when

installed. You will be prompted to type in the Serial Number(located at

the back of the device)

PAGE 1
Register& Update for CR7001, 7001F, 8001, 8011, 8021, 9081 Take CR8011 for example: Follow the steps described as below to perform the registration and update: 1. Go to the launch website: mycar.x431.com and click Products > CR8011. 2. Download and install the Update Tools and launch the program when installed.
PAGE 2
3. After the S/N is entered, click Device Upgrade and enter the following information (e-mail address and register code), click Submit. a) The Register Code can be found when you connect the device to your computer via USB cable. b) When the device has powered up, place the cursor on the Help > Tool information.
PAGE 3
4. Please take the TF card out to the card reader and insert into the computer. 5. Reopen the CR update suite; fill in your user password, click OK.(Note: User password is the Register Code) 6. Select the updates you’d like to perform or click Select ALL and click Download. (Caution: Do not disconnect USB while downloading.
PAGE 4
6. Once the updates are finished, it will pop up the following bar and click OK. 6. Once all steps are completed, please repower up the device via USB in computer. Then click OK to start updating. It may take a while to finish the update.
PAGE 5
7. Now the registration and upgrading process is completed and you can enjoy the updated software. Note: Please make sure the card reader is removed safely.