User Manual

LAUNCH  English User Manual

cable to vehicle’s battery, and the other end to the power jack of OBD I

adaptor.

4.4 Bluetooth Setting

Enter V1M Bluetooth setting screen (“Settings” -> “Bluetooth”), slide

the Bluetooth switch to ON and V1M will start searching available

Bluetooth device, tap the desired connector to pair.

By default, the Bluetooth name is 98729*****00 (where ***** stands for 5 digits.).

Note: In case no Bluetooth setting is done before diagnostic software is launched,

you can also configure it while using the software. For details on Bluetooth connection,

please refer to Chapter 4.5 “Start diagnosing”.