User's Manual

LAUNCH X-431 PAD III User Manual
29
4.5.1 Pairing up via Bluetooth
Refer to Chapter 4.4.3 Vehicle Connection to connect the tablet and VCI
module.
1. Enter Bluetooth setting screen by tapping “Tablet Settings” -> “Bluetooth”,
slide the Bluetooth switch to ON and the tablet will start searching for all
available Bluetooth devices.
Fig. 4-14
2. Tap the desired VCI module to pair and match. By default, the Bluetooth
name of the VCI module is 98********00 (where ******** stands for 8 digits).
3. If the Bluetooth pair request pops up on the screen, input the request pin
code (default code: 0000 or 1234).
4. When pairing is successfully done, the VCI module will be shown on the top
of the “Paired devices” list.
*Notes:
y To make sure that the tablet has paired up with the VCI module via Bluetooth,
“PersonalCenter”‐>“VCIManagement”tocheckwhethertheVCImoduleispaired
upornot.
y If you logged in the account on another diagnostic tool and the
 VCI module has
everbeenpairedupwiththat tool, youneedtocancel pairingfirstbeforeusinga
different tool to proceed new diagnostic session. Tap “Tablet Settings”‐>
“Bluetooth”‐>TapthedesiredDS401connectortounpairit.
In case no Bluetooth setting is done before diagnostic software is launched, you
can also configure it in process of vehicle diagnosis.