User's Manual

LAUNCH X-431 PAD III User Manual
ii
the product, read all of the information in this section before using the product.
y
Never collide, throw, or puncture the tool, and avoid falling, extruding and
bending it.
y
Do not insert foreign objects into or place heavy objects on your device.
Sensitive components inside might cause damage.
y
Do not use the tool in exceptionally cold or hot, dusty, damp or dry
environments.
y
In places using the tool may cause interference or generate a potential risk,
please turn it off.
y
X-431 PAD III is a sealed unit. There are no end-user serviceable parts inside.
All internal repairs must be done by an authorized repair facility or qualified
technician. If there is any inquiry, please contact the dealer.
y
Never place the tool into apparatus with strong electromagnetic field.
y
Keep the tool far away from magnetic devices because its radiations can
damage the screen and erase the data stored on the tool.
y
DANGER: Do not attempt to replace the internal rechargeable lithium battery.
Contact the dealer for factory replacement.
y
CAUTION: Please use the included battery and charger. Risk of explosion if
the battery is replaced with an incorrect type.
Precautions on Using X-431 PAD III
Before using this tool, please read the following safety information carefully.
y
Always perform automotive testing in a safe environment.
y
If the VCI (Vehicle Communication Interface) device remains unused for a
long period of time, it is suggested to unplug the connector from vehicle’s
DLC to conserve battery power.
y
Wear an ANSI-approved eye shield when testing or repairing vehicles.
y
The vehicle shall be tested in a well-ventilated work area, as engines produce
various poisonous compounds (hydrocarbon, carbon monoxide, nitrogen
oxides, etc.)
y
Do not connect or disconnect any test equipment while the ignition is on or
the engine is running.
y
Put blocks in front of the drive wheels and never leave the vehicle unattended
while testing.
y
Keep the tool dry, clean, free from oil, water or grease. Use a mild detergent
on a clean cloth to clear the outside of the equipment as necessary.