User's Manual

LAUNCH X-431 PAD III User Manual
100
ignitionsystems.Itcanbeappliedinthecondition
thatthereareno,orlimitedaccesstoanyspark
plugleads.
9
Multimeter
probes
 
10
Crocodile clips

Designedtoconnectthebareterminalsorleads.
11
Back Probe Pins
Suite
Theyaremainlyusedforpiercingtheinsulationof
wirestoallowforautomotiveelectrical
measurementswithoutcausingdamagetothe
wires.Additionallytheycanbeusedaspin‐tip
probeswhileworkingwithsmallcircuitboards.
12.3 Connection & Initial Use
12.3.1 Probe Compensation
Perform this function to match the characteristics of the probe (optional) and the
channel input. The probe that has not been compensated may cause
measurement tolerance or error.
1. Set the switch to "X10" (the default is X1) on the probe and connect it to the
any Channel of the Scopebox.
2. Follow Steps 1-2 in Item 2 "Connection" mentioned below to connect the
Scopebox and diagnostic tool. Launch the App and open "Scope" to run it.
3. From the "Vertical Setting" menu, select the corresponding channel and set
the Probe attenuation to 1:10.
4. Attach the probe tip to the Probe Compensator and the ground nip of the