User's Manual

18
LAUNCH
X-431 PADII User's Manual
Tap to return to the function selection screen.
5.6 Start Diagnosing
Tap on the main menu screen, and then choose “Diagnose” to
enter the vehicle selection page.
Take Demo as an example to demonstrate how to diagnose a vehicle.
1. Tap the “DEMO” logo, the system will prompt you to make
Bluetooth pair rstly (See Fig. 5-13). Since Bluetooth is not required
for DEMO program, just tap “DEMO SHOW” to proceed to Step 2.
Fig. 5-13
Note: Generally you have to match and pair Bluetooth while
diagnosing a certain vehicle. If Bluetooth pair has been done, “Not
Connected” but “Paired” will appear on the screen. Tap the desired
connector to start connecting. If successful, a pop-up message
“Connected to 98429*****00” will be shown.
2. After Bluetooth is properly connected, the system will enter
software version selection screen. See Fig. 5-14.
Fig. 5-14
To check whether a new version is available or not, tap “Check Latest
Version”. If a newer version is detected, it will start downloading the
latest version.
3. Tap the desired version to start initializing. After initializing is
complete, the screen will display as below:
Fig. 5-15
4 Tap “Demo” to enter system selection interface. See Fig. 5-16.