User's Manual

MAXGo

User's Manual

B. Clipper Cable: Connect one end of the clipper cable to vehicle’s

battery, and the other end to the power jack of OBDI adaptor.

Fig. 5-3

5.2 Bluetooth Setting

Enter MAXGo Bluetooth setting screen (“Settings” --> “WIRELESS

& NETWORK” --> “Bluetooth”), slide the Bluetooth switch to ON

and MAXGo will start searching available Bluetooth device, click the

desired connector to pair and match.

By default, the Bluetooth name is 98409*****00 (where ***** stands for

5 digits.).

Note: In case no Bluetooth setting is done before diagnostic

software is launched, you can also configure it while using the

software. For details on Bluetooth connection, please refer to “Chapter

5.6 Start diagnosing”.

5.3 Diagnosis Flowchart

For new users, please follow the operation chart shown in Fig. 5-4 to

get familiar with and start using MAXGo.

Fig. 5-4

5.4 User and Connector Registration

5.4.1 User registration

Tap the icon on the desktop to launch the application, a disclaimer

page will pop up on the window. Tap “I’ve read it” to enter the login

interface of diagnosis software, as indicated in Fig. 5-5.