User Manual

REPLACE BATTERIES
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver and remove the door.
• Remove the exhausted batteries
and properly dispose.
• Insert three, new AA (LR6)
alkaline batteries.
• Replace the battery compartment
door and tighten the screw. Do not
over-tighten.
• If this toy begins to operate
erratically, you may need to reset
the electronics. Slide the power-
volume switch off and back on.
• When sounds or lights become
faint or stop, it’s time for an adult
to change the batteries.
Battery Safety Information
In exceptional circumstances, batteries
may leak fluids that can cause a
chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries
or batteries of different types:
alkaline, standard (carbon-zinc)
or rechargeable.
• Insert batteries as indicated inside
the battery compartment.
• Remove batteries during long
periods of non-use. Always remove
exhausted batteries from the
product. Dispose of batteries safely.
Do not dispose of this product
in a fire. The batteries inside may
explode or leak.
• Never short-circuit the
battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable
batteries.
• Remove rechargeable batteries
from the product before charging.
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
Protect the environment
by not disposing of this
product or any batteries with
household waste. This symbol
indicates that this product
shall not be treated as
household waste. Check your
local authority for recycling
advice and facilities.
1,5V x 3
AA (LR6)
For longer life, use alkaline batteries.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following
two conditions: (1) this device may
not cause interference, and (2) this
device must accept any interference,
including interference that may
cause undesired operation of
the device.
L’utilisation de ce dispositif est
autorisée seulement aux conditions
suivantes : (1) il ne doit pas
produire de brouillage et (2) il doit
pouvoir tolérer tout brouillage
radioélectrique reçu, même si
ce brouillage est susceptible de
compromettre son fonctionnement.