User Manual

• Open the fasteners on the back of the toy.
• Pull to remove the electronics unit from
inside the toy.
Electronics Unit
• Loosen the screw in the electronics unit
battery compartment door with a Phillips
screwdriver and remove the door.
• Remove the exhausted batteries and
properly dispose.
• Insert two, new AA (LR6) alkaline batteries.
• Replace the battery compartment door and
tighten the screw. Do not over-tighten.
• When sound or light from this toy become
faint or stop, it’s time for an adult to change
the batteries.
• Slide the power switch to
ON or OFF.
• Slide the volume switch to
low volume or
high volume.
• If this toy begins to operate erratically, you
may need to reset the electronics. Slide the
power switch off and then back on.
• Fit the electronics unit back inside the toy.
Make sure the button on the electronics
unit is facing the front of the toy. Close
the fasteners.
1,5V x 2
AA (LR6)