User Manual

Assembly Battery Replacement
• Turn the toy so that the bottom is facing you.
• Fit the feet to the base of the toy. Insert
two screws into each foot and tighten with
a Phillips screwdriver. Do not over-tighten
the screws.
• For longer life, use alkaline batteries.
• Loosen the screw in the battery compartment
door and remove the door. Remove the
exhausted batteries and properly dispose.
• Insert four, new AA (LR6) alkaline batteries.
• Replace the battery compartment door and
tighten the screw.
• If this toy begins to operate erratically, you
may need to reset the electronics. Slide the
power/volume switch off and back on.
• When sounds/lights becomes faint or stop,
it’s time for an adult to change the batteries.
Battery Safety Information
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn injury
or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries
of different types: alkaline, standard (carbon-
zinc) or rechargeable.
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely.
Do not dispose of this product in a fire.
The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are used,
they are only to be charged under
adult supervision.
1,5V x 4
AA (LR6)
CAUTION
This package contains small parts.
For adult assembly only.
M4,0 x 12mm Screw - 4
Shown Actual Size