User Manual

5
Assembly
BOTTOM VIEW
7
• Carefully turn the assembly on its side. Insert
eight screws into the bases and tighten.
8
• Turn the assembly upright.
• Fit the floor to the bases.
Hint: The floor is designed to fit the bases one
way. If it does not seem to fit, turn the floor
around and try again.
Floor
9
• Carefully turn the assembly on its side again.
• Insert four screws into the bases and tighten.
BOTTOM VIEW
6
• Position the bases on a flat surface with the
wide ends facing each other.
• Fit the wall assembly and door lower peg into
the slots and hole in the bases.
Hint: The wall assembly with door is designed
to fit the bases one way. If it does not seem to
fit, reverse the bases and make sure the base
with a hole is on the same side as the door peg.
Bases