User's Manual

November 2010
SiBEAM, Inc.
SB-UG-0004-B 6
Getting Started
SK9210TX-HS Contents
The following items are included in a SK9210TX-HS module:
• DMC board
• Cable
• RF board
Unpacking the Module
The module will come with the two boards already connected. The only action by the user upon opening
the packaging is to locate the DMC board and the RF board as shown in Figure 1.
Figure 1. SK9210TX-HS Module
Customer Supplied Equipment
The customer should have available a Notebook PC with a DMC slot available and accessible. The RF
board is typically mounted on the backside (outward facing) of the LCD panel with the cable running thru
the hinge assembly. RF board shall be positioned to provide at least 0.65 cm from the end user. 0.65 cm
distance is measured by positioning the display section of notebook/Netbook/Laptop computers
perpendicular to the keyboard section. Measure the distance from the nearest point of antenna to the
bottom of host. The PC should be running the 64-bit version of Windows 7. The SK9210TX-HS can
support a number of audio and video formats as listed in Table 1 and Table 2. Also included but not listed
are 3D video formats. The host equipment must be labeled with the following text: “Contains TX module
FCC ID: UK2-SK9210TX-HS” and /or “Contains TX module IC: 6705A-SK9210TXHS”.
The customer will also need a WirelessHD enabled sink device. There are a number of options for this
available on the market or they may use SiBEAM’s SK9200 reference design with the Rx module.