User's Manual

November 2010
SiBEAM, Inc.
SB-UG-0004-B 10
WirelessHD Applications Controller (WAC)
The WirelessHD Applications Controller (WAC) is provided for end user control over the SK9210TX-HS.
Thru the WAC, the end user is able to connect/disconnect from a WVAN, see operating performance and
update code on the module.
Figure 4 shows the Status screen of the WAC. In this screen the user is able to see the signal strength
achieved, if the module is Associated in a WVAN or if there is an active Connection. The signal strength
can be used to provide guidance should there be bad image quality and the user may use this information to
move the source or sink to a better location for reception.
Figure 4. WAC Status Screen
The Network screen is shown in Figure 5. This is the main screen used to make an active connection to a
display. In this screen the user can see the available WVAN’s and select and connect to a particular
WVAN. The HR and LR channel used by the WVAN is also shown.