Installation Manual

radiated power (EIRP) is not more than that required for successful communication. To prevent
radio interference to the licensed service, this device is intended to be operated indoors and
away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is
installed outdoors is subject to licensing.
Pour empecher que cet appareil cause du brouillage au service faisant l'objet d'une licence, il
doit etre utilize a l'interieur et devrait etre place loin des fenetres afin de Fournier un ecram de
blindage maximal. Si le matriel (ou son antenne d'emission) est installe a l'exterieur, il doit faire
l'objet d'une licence.
Caution: Exposure to Radio Frequency Radiation.
The installer of this radio equipment must follow the following guidelines:
a. Module shall be placed inside the lid of the laptop (display portion of laptop) and
that the antenna (RF board) shall be pointed away from the end user.
b. Minimum distance from base plane of laptop to the bottom edge of RF chip shall be
greater than or equal to 3.3cm.
3.3 cm
SIL-SK63100
antenna
(RF board)
c. For minimum distance less than 3.9cm, the orientation of the RF chip shall be
restricted to place the A1 marker located at the top.
The installer of this radio equipment must ensure that the antenna (RF board) is pointed away
from the end user such that it does not emit RF field in excess of Health Canada limits for the
general population; consult Safety Code 6, obtainable from Health Canada’s website
www.hcsc.gc.ca/rpb.
Europe - EU Declaration of Conformity and Restrictions
This equipment complies with the essential requirements and other relevant provisions of
Directive 1999/5/EC.