Installation Manual

Checkpoint: Extended Windows desktop should appear on laptop internal display and
the TV/monitor.
*The WirelessHD connection may be lost if display mode switching is too soon before it gets
stabilized.
OEM Installation Instructions for SIL-SK63100 Module
Interference Statement
USA - Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy. If not installed and used in accordance with the
instructions, it may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
2. This product does not contain any user serviceable components. Any unauthorized product
changes or modifications will invalidate warranty and all applicable regulatory certifications
and approvals.
3. Caution: Exposure to Radio Frequency Radiation: The installer of this radio equipment must
follow the following guidelines:
a. Module shall be placed inside the lid of the laptop (display portion of laptop) and
that the antenna (RF board) shall be pointed away from the end user.
b. Minimum distance from base plane of laptop to the bottom edge of RF chip shall be
greater than or equal to 3.3cm.
3.3 cm
SIL-SK63100
antenna
(RF board)