User Manual

c. For minimum distance less than 3.9cm, the orientation of the RF chip shall be
restricted to place the A1 marker located at the top.
4. The antenna(s) used for this transmitter must not be collocated or operating in conjunction
with any other antenna or transmitter within a host device, except in accordance with FCC
multi-transmitter product procedures. Other antennas shall be installed with a minimum 20
cm separation from the 60 GHz device antenna.
5. Caution: User is cautioned that changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate the equipment.
6. FCC rule 15.255(a) prohibits the use of this device on aircrafts or satellites.
7. This module is intended for the OEM integrator.
Additional note to System Integrator / OEM:
System integrator/OEM needs to ensure that Host system shall have the ability to allow the end
user to disable the transmitter when the modules are used in portable devices that could, for
example, be taken on-board aircraft. Clear instructions as to how to enable and disable the
wireless transmission under such circumstances shall be included in the host system’s user
instructions.
The regulatory label on the final system must include the statement: “Contains FCC ID: UK2-SIL-
SK63100”.
Canada - Industry Canada (IC)
This device complies with RSS 210 of Industry Canada. Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of this device. "
L ' utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas
produire de brouillage et (2) l' utilisateur du dispositif doit étre prêt à accepter tout brouillage
radio électrique reçu, même si ce brouillage est susceptible de compromettre le
fonctionnement du dispositif.
The term "IC" before the equipment certification number only signifies that the Industry
Canada technical specifications were met. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (EIRP) is not more than that required for successful communication. To prevent
radio interference to the licensed service, this device is intended to be operated indoors and