User Manual

SiI-63101 and SiI63102
Quick Start Guide – OEM Installation
Silicon Image, Inc.
6 ©2012 Silicon Image, Inc. All rights reserved.
CONFIDENTIAL
Interference Statement
USA-Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instructions, it may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
2. This product does not contain any user serviceable components. Any unauthorized product changes or modifications
will invalidate warranty and all applicable regulatory certifications and approvals.
3. Caution: Exposure to Radio Frequency Radiation: The installer of this radio equipment must ensure that a minimum
distance of 20cm shall be maintained between the antenna and the users of the host that this module is integrated
into.
4. Caution: User is cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
5. The antenna(s) used for this transmitter must not be collocated or operating in conjunction with any other antenna or
transmitter within a host device, except in accordance with FCC multi-transmitter product procedures. If the module
is installed with other transmitting devices which can transmit simultaneously with this device and antenna-to-
antenna distance is less than 20cm, assessing RF exposure compliance with multiple transmitters within a host
device shall be performed based upon FCC requirements.
Note for system integrators
This module is intended for OEM integrator. The OEM integrator is still responsible for the FCC compliance
requirement of the end product, which integrates this module. 20cm minimum distance has to be able to be maintained
between the antenna and the users for the host this module is integrated into. Under such configuration, the FCC
radiation exposure limits set forth for an population/uncontrolled environment can be satisfied. Any changes or
modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment.
Label of the end product:
For SII-SK63101 module: The final end product must be labeled in a visible area with the following "Contains FCC ID:
UK2-SII-SK63101 ". If the size of the end product is larger than 8x10cm, then the following FCC part 15.19 statement
has to also be available on the label: This device complies with Part 15 of FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
For SII-SK63102 module: The final end product must be labeled in a visible area with the following "Contains FCC ID:
UK2-SII-SK63102 ". If the size of the end product is larger than 8x10cm, then the following FCC part 15.19 statement
has to also be available on the label: This device complies with Part 15 of FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Canada – Industry Canada (IC)
This device complies with RSS 210 of Industry Canada. Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of this device.”