User Manual

SiI-63101 and SiI63102

Quick Start Guide – OEM Installation

Silicon Image, Inc.

CONFIDENTIAL

Getting Started

Follow the procedures described in this section to setup the SiI-SK63101 and SiI-63102 module pair:

1. Unpack the module pair.

2. Place the HDMI Video source and the HDMI video display in the same room at a reasonable distance apart (2 to

10m).

3. Connect the provided HDMI cable between the Tramsitter and the HDMI source output.

4. Connect the other provided HDMI cable between the Receiver and the HDMI display input.

5. Connect the AC/DC adapters to the Transmitter and Receiver.

6. You should see that the Status LED on the front of both the Transmitter and the Receiver are blinking.

7. Power up and configure the HDMI source and the HDMI Display such that they are sending and receiving video

respectively.

8. Ensure that the HDMI display is tuned to the the source input where the HDMI cable from the Receiver is plugged

in.

9. At this time the Display should render the video coming from the HDMI source and both Status LED on the

adapters should be ON.