User's Manual

Module Installation Guide
2 ©2017 SiBEAM, Inc., a Lattice Semiconductor company.
All rights reserved. CONFIDENTIAL
Introduction
The Lattice Semiconductor MOD6212/13 Wireless module provides a data interface
compatible with USB device, which allows reception/transmission of various data rate
from/to any USB compliant device. OEM can develop a system equipped with this module to
wirelessly connect their high data sources to the target device.
The MOD6212/13 modules fit into a variety of industrial designs. No software needs to
initialize and to control the module to achieve the wired connectivity offered. The
MOD6212/13 module is a completely self-contained autonomous wireless sub-system that
connects to a system board that provides the wired connectivity from a single port to a full
featured multiport, multi-standard system. The advantage of this design is that the
complexity of the wireless system, radio performance, regulatory requirements, and
compliance to standards are all eliminated. This system interface carries data, power, and
control signals. The module is pre-certified and is fully tested for fast time-to-market.
MOD6212/13 Diagram
USB3.0/2.0
I2C Tunnel
System
Host
MOD6212
USB3.0/2.0
I/O RST
USB devices
I2C peripherals
System controller
3.3V 3.3V
MOD6213
I2C D ebug
I/O RST
I2C D ebug
I2C Tunnel
Figure 1. MOD6212/13 Transceiver Module Wireless connector principle
MOD6212/13 transceiver Features
• USB 3.0 and 2.0 connections: SS, HS, FS, LS.
• Up to 6Gbps full duplex data-rate
• I
2
C tunneling for remote I
2
C connections
• Fully automatic device detection and connection
• Close proximity operation
• Single chip IC, direct connector replacement
• Integrated antenna
• No software driver required