User's Manual
Table Of Contents
- Page 1
- Page 2
- Page 3
- Page 4
- Page 5
- Page 6
- Page 7
- Page 8
- Page 9
- Page 10
- Page 11
- Page 12
- Page 13
- Page 14
- Page 15
- Page 16
- Page 17
- Page 18
- Page 19
- Page 20
- Page 21
- Page 22
- Page 23
- Page 24
- Page 25
- Page 26
- Page 27
- Page 28
- Page 29
- Page 30
- Page 31
- Page 32
- Page 33
- Page 34
- Page 35
- Page 36
- Page 37
- Page 38
- Page 39
- Page 40
- Page 41
- Page 42
- Page 43
- Page 44
- Page 45
- Page 46
- Page 47
- Page 48
A. Introduction: FCC Compliance Statement
A-03
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause
undesirable operation.
WARNING: Changes or modifications to this watch not
expressly approved by the party responsible for compliance
could void the user’s right to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable prote c t i o n a g a i nst harmful interference in a
residential installation. This equipment generates, uses and
radiates radio frequency energy. If it is not installed and used in
acco rdance with the instruc tions, it may caus e harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interferen ce to radi o or television reception, whic h can be
determined by turning the equipment off and on, the user is
recommended to reduce the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation space between the watch and the
receiver.
Consult the dealer or an experienced radio/TV technician for help.
FCC
Compliance
Statement
(For US)