User's Manual

F. Navigation Function - How to navigate
03F-
Navigation
How to setup the path and navigation mode as described
before. Turn ON GPS by Holding [V]. Or if you want to have
workout logged, just press [S/S] to start workout. Then wait for
GPS to be fixed. At the same time, you can pick the active
waypoint by pressing [V] to switch to the Goto screen.
Set Active Waypoint
On the Goto screen, browse the waypoints up or down on the
current path with [S/S] and [L/R] buttons. The sequence number
of the waypoint is shown at the top right. The Path name is in
th e 2nd line. Other details of the wayp oin t are show n
consecutively in lines 3 and 4 across 3 pages.
- Page 1 shows the time, date, and name of a waypoint. The
name of the waypoint is limited to 10 characters long. Editing of
the waypoint name can only be done in the GPS Master. A
D e f a u l t na m e “ W a y p t X X ” i s a s s i g n e d t o a w a y p o i n t
automatically by the watch when it is marked manually or
created by Smart Lap. Where XX is a sequence number going
from 01 to 99.
- Page 2 shows the distance between the current position and
the heading to this waypoint when GPS has been fixed.
- Page 3 shows the latitude and longitude of this waypoint
Press [V] once again to go back to Navigation after the active
waypoint has been selected.
Direction
Current
Speed
Waypoint
Destination
Workout
Data View
[V]
Path
Name
Waypoint
No.
Navigation
data
Waypoint Data View
Hold
[V]
Fixing with GPS
GPS Fixed