User's Manual

NOTE: Keep batteries
away from children. If
swallowed, contact a
doctor immediately.
CAUTION: Risk of
explosion if battery is
replaced by an incorrect
type.
1
Turn the cover counter-
clockwise with a coin gently
until it pops out.
2
Remove the exhausted
battery and insert a new one
(CR2032) with (-) side
against the metal contact.
4
Turn the cover clockwise
with the coin again until the
little arrow pointed to the dot.
B. Setting Up: B-03
Batteries:
All connectors have user changeable batteries. To change the battery yourself, follow
the instructions below, and see the markings on the connector.
O
P
E
N
CR2032
CR2032
O
P
E
N
O
P
E
N
3
Press the cover back into
the connector.
O
P
E
N
CR2032
CR2032
Make sure the battery
is placed under the
golden slot.
2a
2b
B. Setting Up: B-02
Getting Started:
The heart rate sensor is compatible with Bluetooth
®
smart and Bluetooth
®
smart
ready devices. It may require a separate application to view heart rate data on the
receiving device, such as a watch or a mobile phone.
Pair the heart rate sensor with the receiving device when using it for the first time.
Keep the receiving device in front of you to ensure sufficient transmission range from
the heart rate sensor to your device, such as in a front pocket or fixed on a belt.
DO NOT wear the receiving device on your back, such as in a back pocket or
backpack.
B. Setting Up: B-01
Wear the Heart Rate Sensor:
1
Moisten the electrode areas
of the strap.
2
Attach the connector to the
strap.
3
Adjust the strap length to fit
tightly but comfortably.
4
Tie the strap around your
chest just below the chest
muscles, and attach the
hook to the other end of the
strap.
5
Check that the moist
electrode areas are firmly
against your skin and that
the logo of the connector is
in a central and upright
position.
NOTE:
Detach the connector
from the strap and rinse
the strap under running
water after every use.
Sweat and moisture may
keep the electrodes wet
and the transmitter
activated. This will reduce
the transmitter battery life.
1 Chest Strap
2 Connector
Electrode areas
Hook
O
P
E
N
Battery door
Buttons
Front Back
Naming of the parts:
This product includes 2 parts:
Chest Strap: To be tied around the body
Connector: To send the heart rate
signal to the receiving
device.
Electrode areas: To detect heart rate.
Hook: To fix the strap on user’s chest
Buttons: To attach the connector to the
strap
Battery door: To cover the battery
compartment
A. Introduction: A-05