Assembly Instructions Caution : You must read this before you proceed Bench Part List Label A B C Picture Description QTY Bench Base 1 Metal Leg (with Pre-installed Levellers) Iron Pipe 2 2 Page 1 of 7
Hardware Label Picture Description QTY ① Bolt (M6*20mm) 9 ② Bolt (M6*55mm) 7 ③ Washer 16 ④ Allen Key 1 Assembly Preparation Before Beginning Assembly: Page 2 of 7
Assembly Steps Overview FRONT FACING This Bench has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Bench parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 X5 Bench Base (A) Iron Pipe(C) Metal Leg (B) Place the Bench Base(A), Metal Legs(B) and Iron Pipes(C) on a clean, non-marring surface.
Step 2 Metal Leg(B) Iron Pipe(C) Bench Base (A) Position the Bench Base(A) facedown as shown. Place the Metal Leg(B) on the Bench Base(A) and attach Iron Pipes(C) using Bolts(①) and Washers(③) with Allen Key(④). Tighten the Bolts fully in a sequential manner. Step 3 Iron Pipe(C) Metal Leg(B) Bench Base (A) Place Metal Legs(B) onto Bench Base(A) and align the six mounting positions as pictured above. Attach Metal Legs(B) to Bench Base(A) using Bolts(②), and Washers(③), with Allen Key(④).
Step 4 Metal Leg(B) Iron Pipe( C) Bench Base (A) Attach Metal Legs(B) to Bench Base(A) using Bolts(①), and Washers(③), with Allen Key(④). Tighten the Bolts fully in a sequential manner. Step 5 Adjust Pre-installed Levellevs heighe to achieve balance With assistance from an adult partner, stand the Bench up. Adjust the Pre-installed Levellers at the bottom of the Metal Legs(B) until the Bench is level with the ground.
Step 6 Your Bench is ready for use. This Bench can only be used on a flat, level surface.
Page 7 of 7
