Caution: You must read this before you proceed BARCART 1 OF 10
Label Picture Description QTY A Front Panel 1 B Back Panel With Legs 1 C Bottom Basket 1 D Middle Panel (without glass) 1 E Top Shelf Frame 1 F Wheel 2 G Wine Glass Rack 1 H Glass 1 I Ice Bucket 1 2 OF 10
Label Picture Description QTY ① Wrench 1 ② Spring Washer 3 ③ Washer 3 ④ Bolt (M6*35mm) 13 ⑤ Bolt (M6*45mm) 5 ⑥ Washer 17 ⑦ Bolt (M5*20mm) 5 ⑧ Allen Key 1 ⑨ Allen Key 1 3 OF 10
Before Beginning Assembly: 4 OF 10
Overview Top Shelf Frame (E) Wine Glass Rack (G) Ice Bucket (I) Glass (H) Middle Panel (D) Front Panel (A) Back Panel With Legs (B) Bottom Basket (C) Wheel (F) This Barcart has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Barcart parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 2 Attach Front Panel(A) to Bottom Basket(C) using Washers(⑥) and Bolts(④) with Allen Key(⑧) as shown in the picture. Do not fully tighten the Bolts. Step 3 Attach Back Panel With Legs(B) to Bottom Basket(C) using Washers(⑥) and Bolts(④) with Allen Key(⑧) as shown in the picture. Do not fully tighten the Bolts.
Step 4 Attach Middle Panel(D) between Front Panel(A) and Back Panel With Legs(B) using Washers(⑥) and Bolts(④) with Allen Key(⑧) as pictured above. Do not fully tighten the Bolts. Step 5 Place the Top Shelf Frame(E) facedown. Attach Wine Glass Rack(G) to Top Shelf Frame(E) using Bolts(⑦) with Allen Key(⑨). Fully and Securely tighten the Bolts of the Glass Rack to the Top Shelf Frame in a sequential manner.
Step 6 Attach Top Shelf Frame(E) between Front Panel(A) and Back Panel With Legs(B) using Washers(⑥) and Bolts(⑤) with Allen Key(⑧) as pictured above Note: The Wine Glass Rack(G) should be on the same side of the Front Panel(A). Now in a sequential manner, proceed to tighten all Bolts at all joints. Note: DO NOT fully tighten a BOLT in one go and then move on to the next. Rather, in a sequential manner, gradually tighten each Bolt until all Bolts are evenly secured.
Step 8 Place Ice Bucket(I) into the hole of the Top Shelf Frame(E). Step 9 Your Barcart is ready for use. This Barcart can only be used on a flat, level surface.
What is Proposition 65? Proposition 65 is a California law that requires warning labels on products that may contain one of more than 800-plus chemicals or ingredients that the California Office of Environmental Health Hazard Assessment (OEHHA) has deemed to cause cancer or other reproductive toxicity.
