Installation & Assembly

PART QTY PART QTY PART QTY
1 1 Star Base 5 1
E5
Caster
2 1 Cylinder Column A 4
F2
Cap cover (Upper)
3 1 Seat+Mechanism(pre-assembled
)
B4
G2
Allen Wrench (Lower)
4 1 Back Frame C 4
· USE THIS PRODUCT ONLY FOR SEATING ONE PERSON AT A TIME. · IF ANY PARTS ARE MISSING, BROKEN, DAMAGED OR WORN, STOP USE
· DO NOT USE THIS CHAIR AS A STEP STOOL/LADDER. OF THE PRODUCT UNTIL REPAIRS ARE MADE USING FACTORY
· DO NOT SIT ON ANY PART OF THE CHAIR EXCEPT THE SEAT. AUTHORIZED PARTS.
· DO NOT USE CHAIR UNLESS ALL BOLTS, SCREWS AND KNOBS ARE WARNING: TO AVOID DANGER OF SUFFOCATION, KEEP THIS PLASTIC BAG AWAY FROM BABIES &
TIGHT. CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES, PLAY PENS OR AS HEAD COVERING.
· IT'S ADVISED TO PERIODICALLY CHECK ALL BOLTS, SCREWS
· FAILURE TO FOLLOW THESE WARNINGS COULD RESULT IN SERIOUS INJURY.
AND KNOBS TO BE SURE THEY ARE TIGHT.
Allen Bolt 8 x 25 x 10 mm
Washer
NOTE:The discarded packaging for the unit can be used as a helpful way to support it during the assembly process.
PREVENTIVE MAINTENANCE AND WARNING!
ASSEMBLY INSTRUCTION
Remove all items from the carton.Verify all pieces before assembly
Back Support+Arm(pre-assembled)
Allen Bolt 6 x 25 x10 mm
MECHANISM OPERATION INSTRUCTION
WHILE SEATED:
(A) SEAT HEIGHT ADJUSTMENT:
Pull lever up.Release lever when desired position
is reached
(B) BACK TILT ADJUSTMENT:
Push lever up to release; pull lever down to lock.
(C) TILT TENSION ADJUSTMENT KNOB:
Rotate knob clockwise/counterclockwise to adjust
tilt tension based on body weight.
STEP 1.
AS WITH ALL MOVABLE MECANICAL DEVICES; IT
IS ADVISED TO PERIODICALLY CHECK TO MAKE
SURE ALL BOLTS, SCREWS AND KNOBS ARE
FULLY TIGHTENED TO ENSURE STABILITY.
NOTICE:
ATTACH BACK TO BACK SUPPORT,
AND FULLY TIGHTEN ALL SCREWS.
STEP 3.STEP 2.
STEP 4.
BACKOFCHAIR
UNDERSIDEOFCHAIR
Edge office chair KEEP THIS PAGE FOR FUTURE REFERENCE.