Installation & Assembly

Step 7

Step 8

Step 9

Attach the Left Arm Pillow(B) using the prefabricated Zipper.

Repeat the same process to attach Right Arm Pillow(C).

Connect the Transformer(E) to the corresponding plug at the back of the Chair.

Then connect the Hand Controller(F) to the other plug at the back of the Chair.

Smooth down the fabric flap on the Chair Backrest(A).

Run your hands down both sides of the flap, from top to bottom, allowing the

velcro tape to adhere to the flap under the seat of the chair.

Your Lift Up Chair is ready for use.

This Lift Up Chair can only be used on a flat, level surfaces.