Installation & Assembly (Armless chair)

ManualsBrandsLatitude Run Manuals3-4 Person Patio Conversation SetsGislaine Solid Wood 4 - Person Seating Group with Cushions

Caution: You must read this before you proceed.

Armless Chair

CAUTION: This Chair is NOT a TOY.

Keep your child / children at bay in the process of assembly.

For turning the Chair and to prevent damage to the Chair, 02

persons may be needed to execute this action.

1 of 7

Please look in the Table Top for hardware packs.

Summary of content (7 pages)

PAGE 1
Caution: You must read this before you proceed. Please look in the Table Top for hardware packs. Armless Chair CAUTION: This Chair is NOT a TOY. Keep your child / children at bay in the process of assembly. For turning the Chair and to prevent damage to the Chair, 02 persons may be needed to execute this action.
PAGE 2
No. Picture Description Qty U Backrest Panel 1 V Right Arm Panel (With Pre-installed Levellers) 1 W Left Arm Panel (With Pre-installed Levellers) 1 X Seat Panel 1 Y Support Bar 1 Z Seat Cushion 1 A1 Back Cushion 1 No.
PAGE 3
Before Beginning Assembly: OVERVIEW Back Cushion (A1) Backrest Panel (U) Right Arm Panel (V) Left Arm Panel (W) Seat Cushion (Z) Seat Panel (X) Support Bar (Y) FRONT FACING This Armless Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions herebelow to familiarise the parts and steps before assembly.
PAGE 4
Step 2 Step 2.2 Step 2.1 Place Right Arm Panel (V) facedown as pictured. Step 2.1: Insert dowel on Support Bar (Y) into housing on Right Arm Panel (V). Attach Support Bar (Y) to Right Arm Panel (V) by using Bolts (⑬) and Allen Key (⑮). Step 2.2: Insert dowels on Backrest Panel (U) into housings on Right Arm Panel (V). Attach Backrest Panel to Right Arm Panel (V) by using Bolts (⑬) and Allen Key (⑮). DO NOT FULLY TIGHTHEN BOLTS. Step 3 Place the Left Arm Panel (W) facedown as pictured.
PAGE 5
Step 4 Stand the Chair frame up. Insert Seat Panel (X) onto Chair frame as shown above. Attach Seat Panel (X) with Chair by using Screws (⑭) with Allen Key (⑮). Note: Using Screws (⑭) from inside to outside of Seat Panel (X). DO NOT FULLY TIGHTHEN SCREWS. Step 5 Adjust Pre-installed Levellers height for balance Inspect the Chair and make sure all parts are adequately connected. Carefully sit onto the Chair. This pressure will help align all parts at all joints.
PAGE 6
Step 6 Z Place Seat Cushion (Z) and Back Cushion (A1) onto the Chair, and affix the velcro of Seat Cushion (Z) straps around the Chair as shown above. The Chair is ready to be used. This Chair can only be used on a flat, level surface. Step 7 With assistance from your adult partners, place the Chairs facedown and connect the pre-attached clips to connect the Chairs together.
PAGE 7
of 7