Assembly Instructions

as shown above.
Place the Table on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the Table some 30cm to 50cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the product freely and vertically with the four legs, hitting the
ground, at the same time.
This Drop Test will help to ensure that all parts and gaps reach full
alignment status.
Test again for evenness on a LEVEL SUCFACE.
If no wobbles found, proceed to tighten all the Bolt and Screws at all
joints.
When tightening the Bolts and Screws, tighten sequentially.
DO NOT tighten any Bolt or Screw fully and then move on
towards the next one.
This would couse the frame to warp.
If there is still wobbles, loosen the Bolts and execute this same
drop test.
Align the support leg (C) and support leg (D) into the mortise leg (B)
Step 4
Then insert a JCBC W Screw(⑥) into hole.
Step 5
Do not fully tighten the Screw.
Turn the table side up.
inspect it and make sure all parts are adequated connected.
Page 4 OF 5