Assembly Instructions

Then insert a Spring Washer (③) and JCBC Bolt(⑤) with Allen Key(②)
Do not fully tighten the Bolts.
Do not fully tighten the Bolts.
into hole。
Step 1
Unpack and place all parts on a clean,non-marring surface.
Step 2
Place the leg support (C) and leg support (D) onto a clean, soft surface
to avoid any scratches or damages to the product.
Align the support leg (C) into the mortise support leg (D) as shown above.
Step 3
Place the table (A) onto a clean, soft surface to avoid any scratches or
damages to the product.
Align the leg (B) into the mortise table (A) as shown above.
Then insert Flat Washer (④), Spring Washer (③) and JCBC (①) with Allen
Key(②)into hole coner.
Page 3 OF 5