Assembly Instructions

ManualsBrandsLatitude Run Manuals2 Seat Kitchen & Dining TablesGorecki Bar Height Dining Table

Label Picture Description QTY

A Table Top 1

B Leg 4

C Leg support (up) 1

D Leg support (down) 1

Hardware

Label Picture Description QTY

①

JCBC Bolt

( M6 x 50mm )

②

Allen Key ( M4mm ) 1

③

Spring Washer 11

④

Flat Washer 9

Parts list

Assembly Instructions

Caution : You must read this before you proceed

BAR TABLE

Page 1 OF 5

Summary of content (5 pages)

PAGE 1
Assembly Instructions Caution : You must read this before you proceed BAR TABLE Parts list Label Picture Description QTY A Table Top 1 B Leg 4 C Leg support (up) 1 D Leg support (down) 1 Description QTY Hardware Label Picture ① JCBC Bolt ( M6 x 50mm ) 9 ② Allen Key ( M4mm ) 1 ③ Spring Washer 11 ④ Flat Washer 9 Page 1 OF 5
PAGE 2
⑤ JCBC Bolt ( M6 x 30mm ) 2 ⑥ JCBC W Screw ( M6 x 50mm ) 5 Assembly Preparation Before Beginning Assembly: • Read instructions, cover to cover• Have 2 adults on hand for assembly• Do not assemble on flooring or carpet• Assemble on a clean non-marring surface (packing foam)• Save all packaging untill finished- Assembly Steps Overview (A) (B) (C) (D) This table has multiple parts and may require up to 30 minutes to assemble.
PAGE 3
Step 1 Unpack and place all parts on a clean,non-marring surface. Step 2 Place the leg support (C) and leg support (D) onto a clean, soft surface to avoid any scratches or damages to the product. Align the support leg (C) into the mortise support leg (D) as shown above. Then insert a Spring Washer (③) and JCBC Bolt(⑤) with Allen Key(②) into hole。 Do not fully tighten the Bolts. Step 3 Place the table (A) onto a clean, soft surface to avoid any scratches or damages to the product.
PAGE 4
Step 4 Align the support leg (C) and support leg (D) into the mortise leg (B) as shown above. Then insert a JCBC W Screw(⑥) into hole. Do not fully tighten the Screw. Step 5 Turn the table side up. inspect it and make sure all parts are adequated connected. Place the Table on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the Table some 30cm to 50cm high from the ground. Keep your feet and toes well away from the drop zone.
PAGE 5
Step 6 Your Bar Table ready for use. This Bar Table can only be used on a flat, level surface.