Installation & Assembly

Step 7
Place the barstool on a LEVEL SURFACE to check for wobbles.
If it wobbles lift the barstool to some 30cm to 50cm height from the ground.
Keep your feet and toes well away from the drop zone.
Drop the barstool freely and vertically with the four legs, hitting the ground, all at the same
time.
This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment
status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles found, slowly and steadily, turn the chair upside down.
Then, proceed to tighten all bolts in a sequential manner.
CAUTION : When tightening these bolts, tighten sequentially.
DO NOT tighten any screw fully and then towards the next one.
This would cause the frame to warp.
If there is still wobbles, loosen the bolts and execute this same drop tests.
WARNING!! IF DINING CHAIR IS NOT STABLE , IT COULD LEAD TO DAMAGING THE
PRODUCT.
Step 8
Place Bolt Caps(④) on Bolts as shown.
Your Barstool is ready for use.