Owner Manual

Table Of Contents
Page 7 of
13
Step 4:
Remove the Electronic igniter Cap(14) on the
Electronic igniter (14) by unscrewing and slide
the Battery(B) into the battery slot(14).Make
sure the positive side of the Battery(B) faces
outwards.Screw the Electronic Igniter Cap(14)
over the battery,tightly.
Step 5:
Subject to your preference,you may pour
Lava Rocks over the Burner Ring.
The Guard MUST NOT BE BLOCKED.Refer to
guidance below:
Do not place more than 1/4 inch depth of lava
rocks above the burner holes.Doing so will
suffocate the flame.
Do not place more than 13.2lb of lava rocks
above the burner holes.Doing so will suffocate
the flame.
WARNING:Fire Table and LP-Cylinder must be
at a minimum of 60 inches apart.
Assembly Instructions
To ensure proper function,the
Guard (01) on the Burner (08)
should never have lava rocks (A)
covered over it.