Owner Manual

Page 9 of 13
LIGHTING INSTRUCTIONS
1. Make sure the control knob (13) is in the “off” position.
2. Open the door (07) (if the unit has a door) and slowly openf the
valve (22) on the propane gas tank by turning the knob (13)
counterclockwise.
3. Close the door (07) on the Main Frame (06) of the Fire Table.
4. Push and hold the electronic igniter (14) to create sparks within the
electrode, continue to hold.
5. Push in the control knob (13) and turn to the “low”
position. Keep holding the control knob (13) to allow gas to flow for
15 seconds.
6. If ignition does not occur within a few seconds release the control
knob (13) and rotate to the “off” position. Wait for 5 minutes for gas to
clear and then repeat the above lighting instructions.
7. Once the product is lit, the flame intensity may be controlled by
turning the control knob (13) between the “low” and “high” positions.
8. Observe flame height when lit:
1) Flame color should be yellow/blue.
2)Flame height burns at 2-20 inches high.
HOW TO EXTINGUISH ?
• Turn control knob (F) clockwise to the “low” position; let the knob
pop up and continue turning the control knob (F) to the “off”
position.
• Wait 5 minutes after extinguishing flame prior to placing a lid (if
applicable) or protective cover on heating item.
• Close the cylinder valve on the propane gas tank if you don’t intend
to use it for a long time.
Operation