Fire Table
CONTENTS • Warnings ................................................................ 1-4 • Diagram ................................................................... 5 • Assembly ................................................................ 6-7 • Operation ................................................................8-9 • Maintenance & Storage ................................... ...... 10 • Trouble Shooting ....................................................
Page 1 of 13 Warnings DANGER CARBON MONOXIDE HAZARD ● This appliance can produce carbon monoxide which has no odor. Using it in an enclosed space can kill you. ● For outdoor use only. ● Never use in the unventilated or enclosed areas. IF YOU SMELL GAS: ● Shut off gas to the appliance. ● Extinguish any open flame. ● If odor continues, keep away from the appliance and immediately call your gas supplier or fire department for help.
Page 2 of 13 Warnings WARNING ● The installation of this unit must adhere to local codes or either the National Fuel Gas Code, ANSI Z223. 1/NFPA54, OR CAN/CGA- B149.1, National Gas and Propane Installation Code. ● This unit is to be used with propane gas only! (sold separately), is not intended for natural gas. ● Do not use any solid fuel or charcoal for this unit. ● Do not use any more than 1/4in depth lava rocks/ pumice stones/ Lava Glass above the burner holes. Doing so will suffocate the flame.
Page 3 of 13 Warnings WARNING ● The tank system must be set up for vapor with drawal. ● Keep away from the unit for the first 20 minutes after igniting your unit for the first time,as pumice stones/fire glass could pop out and cause injury.Should any rocks pop out,discard them. ● Always ensure that lava rocks/pumice stones/fire glass are completely dry before use. ● Do not paint or color any part of this Fire Table. ● Do not sit or rest hands or feet on this Fire Table.
Page 4 of 13 Warnings WARNING ● Do not operate unit until all parts are fully assembled. ● Do not attempt to move it while in use. ● This unit is not intended for cooking. ● Young children must never operate this fire table.They should be carefully supervised AT ALL TIMES while near the area of the appliance. ● Do not hang clothing or any other flammable materials from the fire pit, or place on or near the fire pit.
Page 5 of 13 Parts Diagram & List ,WHP 3LFWXUH 'HVFULSWLRQ 4W\ *XDUG 7KHUPRFRXSOH *URXQG :LUH ,JQLWLRQ 3LQ %XUQHU 3ODWH 0DLQ )UDPH RI Fire Table /DYD 5RFN Burner 1R]]OH &RUUXJDWHG 3LSH 6ZLWFKLQJ 9DOYH 5HJXODWRU 9DOYH ZLWK *DV +RVH &RQWURO .
Page 6 of 13 Assembly Instructions Step 1: Check that the control knob (13) for the gas supply system is turned to the “OFF” position before starting any assembly. Step 2: Place a 20 lbs Propane Gas Tank (not included) into a secure position.Put it into the tank holder (17).Turn the wing screw on the outside of the tank holder (17) clockwise to tighten the tank into the tank holder. DANGER Propane tank must be a minimum of 60 inches away at all times.
Page 7 of 13 Assembly Instructions Step 4: Remove the Electronic igniter Cap(14) on the Electronic igniter (14) by unscrewing and slide the Battery(B) into the battery slot(14).Make sure the positive side of the Battery(B) faces outwards.Screw the Electronic Igniter Cap(14) over the battery,tightly. Step 5: Subject to your preference,you may pour Lava Rocks over the Burner Ring. The Guard MUST NOT BE BLOCKED.
Page 8 of 13 Operation FOR YOUR SAFETY, READ BEFORE LIGHTING • Before performing a leak test, make sure that no sparks can occur and you are in a spacious outdoor area. • Connect the propane gas tank to the regulator and turn the valve on the unit to the “off” position. • Brush a soap and water mixture on all connections. • Make sure the igniter battery has been installed properly. The igniter will not operate otherwise.
Page 9 of 13 Operation LIGHTING INSTRUCTIONS 1. Make sure the control knob (13) is in the “off” position. 2. Open the door (07) (if the unit has a door) and slowly openf the valve (22) on the propane gas tank by turning the knob (13) counterclockwise. 3. Close the door (07) on the Main Frame (06) of the Fire Table. 4. Push and hold the electronic igniter (14) to create sparks within the electrode, continue to hold. 5. Push in the control knob (13) and turn to the “low” position.
Page 10 of 13 Maintenance & Storage To enjoy years of outstanding performance from your heater, make sure you perform the following maintenance activities on a regular basis: • Before performing any maintenance always disconnect propane gas tank. • Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents. • Keep the heating item free and clear from combustible materials. • Visually inspect burner for obstructions and keep tank enclosure free and clear from debris.
Page 11 of 13 Trouble Shooting PROBLEM Burner will not light using igniter Burner will not light with match The fire table emits a lot of black smoke when in use Sudden drop in gas flow, or a reduced flame height CAUSE Electrode and burners are wet SOLUTION Wipe dry with cloth. Igniter battery is dead or backwards Check that the AAA battery is inserted correctly in the igniter or replace the battery.Make sure the plastic wrap on the battery has been removed.
Page 12 of 13 Trouble Shooting Problem: Burner JUST LIGHT UP FOR SECOND AND WILL AUTOMATICALLY TURN OFF PILOT GUARD 1 2. 3 . THERMOCOUPLE IGNITION PIN 4 . IGNITION PIN THERMOCOUPLE 1. The thermocouple will be under the Pilot Guard on the top of the unit. Please remove the Pilot guard by unscrewing it from the metal bowl with a screw driver. 2. Once the Pilot Guard has been removed, you will have two components exposed; the copper one is your thermocouple.
Page 13 of 13 Warranty Information This product has been manufactured under the highest standards of quality and workmanship. We warrant to the original consumer that all aspects of this product will be free of defects in material and workmanship for one year from the date of purchase. A replacement for any defective part will be supplied free of charge for installation by the consumer. Defects or damage caused by the use of other than genuine parts are not covered under this warranty.