Owner Manual

6
6. INSTALLATION OF
SAFETY SUPPORT
An additional safety support is provided to
prevent the fan from falling. Secure the
safety cable to the ceiling joist with screw
and washer, as illustrated in Figure 11.
7. MAKE THE ELECTRIC
CONNECTIONS
WARNING: To avoid possible electrical
shock, be sure electricity is turned off at
the main fuse box before wiring.
NOTE: This remote control unit is
equipped with 16 code combinations to
prevent possible interference from or to
other remote units. The frequency
switches on your receiver and transmitter
have been preset at the factory. Please
recheck to make sure the switches on
transmitter and receiver are set to the
same position, any combination of
settings will operate the fan as long as the
transmitter and receiver are set to the
same position. (Figure 12)
Step 1. (Figure 13) Insert the receiver
into the mounting bracket with the flat
side of the receiver facing the ceiling.
Step 2. (Figure 14) Motor to Receiver
Electrical Connections: Connect the
black wire from the fan to black wire
marked "TO MOTOR L". Connect the
white wire from the fan to the white
wire marked "TO MOTOR N" from the
receiver. Connect the blue wire from the
fan to the blue wire marked "For Light"
from the receiver. Secure the wire
connections with the plastic wire nuts
provided.
Hanger bracket
Safety cable
Figure 11
Figure 12
Figure 13
Code switch
ON
ON
Receiver
Hanger
bracket