Owner Manual
09
------------------------
MASSAGE
CHAIR
SPECIFICATIONS
Model No.
Rated Voltage
Rated Frequency
Rated Power Consumption
Timer
Dimension
Gross Weight
Net
Weight
Usage condition
Safety feature
S5
AC120V
60HZ
150W
5/10/15/20/30 minutes
47.2 x 29.9 x 47.2 Inches
216
LBS
171.96
LBS
Environment temperature: 10°C-40°C
Contrasting humidity: 30-85RH
Equipped with overheated and
power
surge safe protection
MAINTENANCE
AND
STORAGE
CLEANING
XPrior to the maintenance work, make sure to disconnect the power cord. Be careful
that hands must not be
wet
to be
wet
to prevent electric shock or injury.
XDo not use benzene, thinner or alcohol to clean the chair, nor spray any liquid
containing any chemical agents to prevent the risk
of
electric shock or catching fire.
XDo not iron to prevent damage to the fabric.
For main body, areas covered with synthetic leather, back pad, pillow and
seat
cushion
Use a dry cloth moistened with diluted neutral detergent and thoroughly wrung out to
clean the chair, and then wipe with a dry cloth to completely remove the residual
detergent. Thereafter, allow the parts to dry naturally.
For Remote controller
Use a dry cloth to clean the remote controller.
Never use a
wet
cloth for cleaning to avoid malfunction.
STORAGE
XDo not place the unit
in
areas exposed to direct sunlight, or near heaters, hot air
blowers or any other heating devices to avoid discoloration or deterioration on the
surface
of
the holster.
1.
Wipe
off
dust and dirt on the chair each time after use.
2.
Keep the chair clean and away from places
of
high humidity.
3.
If the chair will be laid aside for a long period
of
time, cover it with a dust cover and
unplug its
power
cord.
MASSAGE
CHAIR
------------------------
TROUBLESHOOTING
PROBLEM
The rollers and the backrest
pad make frictional sound.
Motor sound
is
clearly hearable
during operation.
Loud sound
is
given when
tapping and kneading massage
is
performed
Massage
is
suddenly stopped
and the massage rollers return
to their original position.
The remote controller does
not work.
The power cord and plug are
excessively hot.
The massage stops
in
the
process.
SOLUTION
This
is
the sound produced by mechanical
structure instead
of
failure
of
internal components.
This may occur during normal operation.
*The preset auto-timing has been reached.
*In
order to avoid the massage armchair from
causing accident due to overheat, this chair
is
equipped with overheat reboot protection
equipment.
If the chair stops and fails to restart
as
a result
of
overheat, turn off the main power switch for at least
30
minutes
in
order to prevent it from suddenly
starting after components are cooled down.
*The power button was pressed accidentally.
*Check the power plug and ensure that it
is
indeed plugged into the socket.
*Check whether the lines on the back
of
the
massage chair are properly connected.
*Confirm the main power switch
is
turned on.
Stop using immediately and contact the service
centre.
Turn
off
the main switch on the back
of
the chair
and turn on 5 seconds later. If the same problem
is
occurred again, please turn
off
the main switch, unplug the
power
cord and
contact the customer service.
10