Installation & Assembly

NOTE:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets cooler. For best
performance, gently clean the lens with a soft cloth every
1 or 2 months to assure maximum sensitivity.
2. For best performance, install fixture at least 6 feet above
The ground. At such a height, the lantern will provide a
detection distance of up to 40 feet at 77 degrees
Fahrenheit.(See Fig.2)
3. The sensor detects across a detection range of 220
degrees.(See Fig.3)
4. The sensor will be more sensitive to motion across its
detection path than motion directly towards it. (See Fig.4)
5. To reduce possible nuisances, do not mount the fixture
near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflecting object or
other light source.
Troubleshooting
SYMPTOM Possible Cause Solution
the light doesn't work in
Test Mode
Wall switch or circuit breaker is off
The wiring is mistake
Turn on a switch or circuit breaker.
Check wire connections.
Wall switch or circuit breaker is off Turn on a switch or circuit breaker.
Light bulb may be dead.
Test the light bulb in a known
working light fixture
Light bulb is loose. Tighten the light bulb in the socket.
Incorrect or loose wire connections. Check wire connections.
Too much sunlight is shining into the
Dusk-to-Dawn sensor in the early
evening.
Relocate fixture away from a
western facing wall.
In Auto mode, the lighting
fixture does not turn on
when there is motion
Too much light is shining onto the
Dusk-to-Dawn sensor due to another
light source, such as a street lamp or
other light fixture.
Eliminate or turn off other light
source, block other light source
from shining onto Dusk-to-Dawn
sensor, or relocate fixture.
In Auto mode, the lighting
fixture stays on at
100%
brightness
continuously.
False triggering caused by a heat source,
such as a heater or dryer vent, or heated
swimming pool.
Eliminate heat source or relocate
fixture
the lighting fixture comes
on at 100% brightness for
no apparent reason
False triggering caused by a heat source,
such as a heater or dryer vent, or heated
swimming pool.
Eliminate heat source or relocate
fixture
The lighting fixture comes
on during the daytime or
too early in the evening
The fixture may be installed in a shaded
area, such as under a porch or eave,
preventing daylight from shining onto the
photocell sensor.
Relocate the fixture
In Manual override, the
light stays on after dawn
the ambient light level is too low Relocate the fixture
FIG.3
FIG.4
FIG.2