Owner Manual

Assembly Steps
8 OF 10
Step 8
Exert pressure floorwards, onto the Barstool with both your hands.
This pressure will help the Legs and Barstool reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten Bolts and Screws in a sequential manner,
until evenly secured.
When tightening Bolts and Screws tighten sequentially.
Do not tighten any Bolt and Screw fully then move on towards the next one.
If there are still wobbles after tightening, loosen Bolts and Screws and excute the
same above process.
Your Barstool is ready for use.
This Barstool can only be used on a flat, level surface.