INSTRUCTION MANUAL
ASSEMBLY GUIDE Attention: Please open the zipper at the back of the chair, and take out armrests.
Package List Without further ado, we kindly suggest you to list all parts needed for the chair first.
Assembly Instruction Step 1: (9)×2 Turn the Base (7) upside down, and then insert the Legs (6) one by one into the Base. Use the Wrench (14) to screw Ten Bolts (9) into the pre-drilled screw holes to fix the Base and the Legs. 1 (7) (6) 2 (5) Step 2: Press the Casters (8) into the holes at the end of each Base Leg. And then insert the Gas Lift (5) center hole of the Base.
Step 3: Align the Mechanism (4) over the pre-drilled holes underneath the Seat Cushion (2). Then fix it with the Bolts (10), finally insert it into the Gas Lift (5). (4) (2) ( Note: Don't make the direction wrong ) 4 (3) 50% (11) 3 (10) 50% (11) Step 4: Fix the right and left Armrest (3) with the Bolts (11). To make sure to assemble the backrest easily, do not make the bolts fully tight.
Step 5: Fix the Backrest (1) with Bolts (12), finally cover the screws hole with the Lids (13). 5 (1) + (13) (12) + (12) (13) CAUTION: Make sure all bolts and screws are fully tightened before using chair. Lubricate all moving parts and tighten all bolts/screws every 6 months or whenever needed.
Instructions For Use 1. Seat Height: Paddle-shaped lever on the right side To raise: While taking your weight off chair, lift lever up. To lower: While seated, lift lever up. * At the proper height, your feet should rest flat on the floor. 2. Tilt Tension: Long stem under the seat with knob + - To increase tension: While seated, turn knob forward (Counter clockwise). To decrease tension: While seated, turn knob backward (Clockwise ).
3. Operating the tilt lockout To let your chair tilt back, pull the control handle out. To stop your chair from tilting, sit forward, then push the control handle in.
Safety And Maintenance Do not stand on the chair, Do not use the chair as a stepladder. Use this product for seating one person at a time. Do not use the chair unless all bolts and screws are firmly secured. Avoid contact with sharp objects to prevent puncturing the fabric. Every 6 months, check all bolts and screws to ensure they are tight. To clean, spot clean only using a damp towel and mild cleaner, first test on a small, unseen area of fabric. Chair weight limit not to exceed 250 lbs.
