Owner Manual

Step 5
Step 6
Attach the Cushion Seat(G) to the Front Stretcher(C) and the Rear Stretcher(D) with Screws (②), using a
Screwdriver(⑥) as shown above.
Place the Chair on a Level Surface to check if it wobbles.
If it wobbles, lift the Chair some 30cm to 50cm from the ground, keeping your feet and toes well away from the
drop zone, drop the Chair freely and vertically with the four legs hitting the ground at the same time.
This Drop Test will help to ensure that all parts and gaps reach full alignment. Test again for evenness on a
Level Surface.
If no wobbles are found, proceed to tighten all the Bolts and screws.
When tightening the Bolts and screws, tighten sequentially.
Do not tighten any Bolt or screw fully and then move on towards the next one, as this could cause the
frame to warp.
If it still wobbles, loosen all Bolts and screws, repeat the same drop test, then proceed to tighten the
bolts and screws again, sequentially.
Page 6 OF 7