Installation Guide

Figure 4
STEP 4 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
STEP 5 - Install the Fixture Body
A. Position the backplate and Fixture Body (C)
onto the Crossbar Assembly (A). Place the
holes in the backplate over the mounting
screws or alternate short mounting screws.
Secure the Fixture Body by using the
mounting balls and hand tighten the
mounting balls until snug.
Figure 5
STEP 6 Install Bulb and- Apply
Silicone Sealer
A. Insert the bulb onto the socket
and screw snugly into place.
B. Make sure the exterior wall
surface and fixture backplate
are free of dirt before applying
caulk. Using exterior grade
caulk, caulk over top of
backplate and down both
sides. Do not caulk the bottom
of the fixture backplate to
ensure proper moisture
drainage.
Your fixture is now assembled
and ready to use. Enjoy!
Exterior
Grade Caulk
Exterior
Grade Caulk
Backplate
Figure 6
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4"
Socket
Vintage Bulb
(recommended
but not included)
Backplate
Mounting Ball
C
Hex Nut and
Lock Washer
A
7”
5.75”
2.25”
5.5”
14.5”
Fixture can
only be
mounted in
the direction
indicated
FINISH: STAINLESS STEEL
4.5”
2of2