Owner’s Manual

ASSEMBLY

7. Attach the table top (D) to the panel

construction by aligning the holes at the bottom

of the table top (D) to the holes in the top of the

panel construction and securing with four M8 x 16

bolts (DD) and four M8 washers (EE); tighten with

wrench (II). Be sure to position the control panel to

be over the door panel (H).

adjusting and tightening to ensure the structure is

sturdy.

9. Remove the rubber cap on the electronic igniter

(L) by unscrewing and slide battery (M) into the

battery slot. Make sure the positive side of the

battery faces outwards. Screw the electronic

ignitor cap (L) over the battery tightly.

To ensure proper function, the guard (J) on this

burner (I) should be free of LavaGlass™ at all

times.

CAUTION